Ceramic Workshop Reference & Desk

ClayCaliper Support

Offline documentation, shrinkage calibration tips, kiln curve guidance, and email draft contact for ClayCaliper.

§1 Quick Workshop Guide

100mm Shrink-Bar Calibration

Roll a uniform test slab, incise two marks 100.0 mm apart while plastic, then enter dried and glaze-fired measurements under Calibrate to store a custom clay body.

573°C Quartz Inversion Check

Kiln ramps crossing 550°C–595°C above 110°C/hr trigger an automatic thermal shock warning so you can slow down before quartz conversion.

Specific Gravity Glaze Slurry

Water estimates solve for target slurry density (1.38–1.56 g/cm³) from dry mineral volume, helping you mix consistent dip buckets.

Offline Ledger & Backups

All throwing specs, firing logs, and glaze formulas stay on your device. Use Ledger → Share to export PDF spec sheets, CSV tables, or JSON backups.

§2 Contact Studio Support

Direct mailbox: support@example.com (development placeholder address — replace SUPPORT_EMAIL in this file before public distribution). Submitting below prepares a pre-filled draft in your default mail client; nothing is transmitted from this page automatically.
Prepared Email Draft (Ready to Copy & Send Manually)